AGFA G139 DEVELOPER

AGFA G139 developer is Agfa excellent three-parthigh-quality xray chemicals.

Agfa healthcare. G139 developer is a high-quality developer for high-end automatic processors. It is used for conventional blue and green radiography and for laser imaging films. G139 is Agfa’s developer which performs well in all large 90 seconds to 2 minutes processors at temperatures ranging from 32 °C to 35 °C. The best results are obtained when combining the G139 developer with the G334(i) fixer.

ORDERQuestion

Deatails

Temperature adjustment of the developer by 1 °C equals speed adjustment by 2 to 3 log E points.
All kinds of processors, except tabletop processors Not suited for manual processing.
All processing cycles from 90 s to 180 s
Ranging from 300 to 600 ml/m²
One shipping carton G139 contains concentrate for 2×20 l. of developer
Consult the Safety Data Sheet (SDS) for information relating to safety, health and environmental aspects. Please follow the safety instructions mentioned on the bottles carefully.
Make sure the processing room is well ventilated: air ventilation of 10 times the room volume per hour will prevent build-up of chemicals in the air.

A Special Thanks

Leave your request or question for G139 Developer

OPTION

6 + 2 =

Become our partner Today!

Contact UsAbout

SIMILAR PRODUCTS

X-OMAT EX II

X-OMAT EX II

Featuring high contrast and cold image tone, this developer is optimized for mammography and high-tier radiography lms – but provides excellent results with all Carestream general radiography lms. Its advanced formulation signi cantly cuts replenishment for lower...

G138I DEVELOPER

G138I DEVELOPER

G138i is a three-part developer that is Agfa’s standard universal developer for automatic processing in conventional systems.G138i can be used in all current automatic processors. HT, IP or RP processing, G138i always performs excellently. In order to obtain constant,...

No Results Found

The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.

G138Si STARTER

G138Si STARTER

It is recommended to use G138Si starter each time you replace developer. Adding 25 ml of G138Si starting solution per liter of replenisher will allow you to obtain images featuring optimum sensitometric characteristics. Moreover, the difference in image quality during...

Pin It on Pinterest

Share This