X-OMAT EX II
Developer and replenisher yields superb image quality on the viewbox and helps users comply with even the most stringent environmental regulations.Featuring high contrast and cold image tone, this developer is optimized for mammography and high-tier radiography lms – but provides excellent results with all Carestream general radiography lms. Its advanced formulation signi cantly cuts replenishment for lower costs and reduced usage of processing efuent
Deatails
Ideal for mixed-film environments, this versatile performer is suitable for standard-cycle processing with mammography films, and standard- or rapid-cycle processing with general radiography films and MIN-R EV Film.
Processing consistency. Reduced sensitivity to replenishment variation when used with MIN-R 2000 Plus and MIN-R S mammography films.
Clear viewing advantages. Yields high contrast and bluer image tone, for excellent visualization of detail and viewing ease.
Environmental Compliance non-hazardous formulation (without gluteraldehyde) has less-regulated transport and fewer shipping surcharges. Easier to store.
Reduced odor and faster mixing acetic-acid-free formulation
X-Omat EX II developer and replenisher cuts replenishment rate up to 40 percent compared to Carestream recommended replenishment guidelines with all T-Grain emulsion films. These include T-MAT films, INSIGHT films, and X-SIGHT films. Reduced replenishment means lower costs and less processing effluent for reduced environmental impact.
A Special Thanks
Leave your request or question
SIMILAR PRODUCTS
G139 DEVELOPER
Agfa healthcare. G139 developer is a high-quality developer for high-end automatic processors. It is used for conventional blue and green radiography and for laser imaging films. G139 is Agfa’s developer which performs well in all large 90 seconds to 2 minutes...
G138I DEVELOPER
G138i is a three-part developer that is Agfa’s standard universal developer for automatic processing in conventional systems.G138i can be used in all current automatic processors. HT, IP or RP processing, G138i always performs excellently. In order to obtain constant,...
G334(I) FIXER
Agfa HealthCare’s two-part fixer, G334(i), excels by a lower emission of process-specific odors. This has been achieved by reducing the emission of both acetic acid and sulfur dioxide. The power and the accuracy of the fixer have not diminished and you will not,...
G138Si STARTER
It is recommended to use G138Si starter each time you replace developer. Adding 25 ml of G138Si starting solution per liter of replenisher will allow you to obtain images featuring optimum sensitometric characteristics. Moreover, the difference in image quality during...