AGFA G334(I) FIXER

Is Agfa HEALTHCARE standard two-part universal fixer .

Agfa HealthCare’s two-part fixer, G334(i), excels by a lower emission of process-specific odors. This has been achieved by reducing the emission of both acetic acid and sulfur dioxide. The power and the accuracy of the fixer have not diminished and you will not, therefore, need to increase the replenishment rates of the processor.

ORDERQuestion

Details about the G334(i)

• All kinds of processors, except tabletop processors • Not suited for manual processing.
• All processing cycles
• Ranging from 300 to 800 ml/m²
• One shipping carton G334 contains concentrate for 2 x 20 l of fixer
• One shipping carton G334i contains concentrate for 2 x 25 l of fixer
• Make sure the processing room is well ventilated: air ventilation of 10 times the room volume per hour will prevent build-up of chemicals in the air.
• Consult the Safety Data Sheet (SDS) for information relating to safety, health and environmental aspects. Please follow the safety instructions mentioned on the bottles carefully.

A Special Thanks

Leave your request or question for G334 I Fixer

OPTION

11 + 15 =

Become our partner Today!

Contact UsAbout

SIMILAR PRODUCTS

G139 DEVELOPER

G139 DEVELOPER

Agfa healthcare. G139 developer is a high-quality developer for high-end automatic processors. It is used for conventional blue and green radiography and for laser imaging films. G139 is Agfa’s developer which performs well in all large 90 seconds to 2 minutes...

G138I DEVELOPER

G138I DEVELOPER

G138i is a three-part developer that is Agfa’s standard universal developer for automatic processing in conventional systems.G138i can be used in all current automatic processors. HT, IP or RP processing, G138i always performs excellently. In order to obtain constant,...

X-OMAT EX II

X-OMAT EX II

Featuring high contrast and cold image tone, this developer is optimized for mammography and high-tier radiography lms – but provides excellent results with all Carestream general radiography lms. Its advanced formulation signi cantly cuts replenishment for lower...

G138Si STARTER

G138Si STARTER

It is recommended to use G138Si starter each time you replace developer. Adding 25 ml of G138Si starting solution per liter of replenisher will allow you to obtain images featuring optimum sensitometric characteristics. Moreover, the difference in image quality during...